![]() ![]() The Night Sabre security light has a flashing red LED to let you know it’s powered on and ready. Connect the cable to the power supply and plug it into an indoor wall socket. To mount the light simply fit one edge into the top or bottom of the clips then twist it round until it clicks into place. Alternatively if the light is going under a windowsill you can simply feed the cable through a window – it’s low voltage so no risk in doing this. If you want to hide the cable you might need to drill a 10mm hole through the wall or ceiling near one end of the light, pass the power cable through the hole. The distance between the clips isn’t critical as they can fit on anywhere along the length of the aluminium part of the light. Screw the 2 mounting clips about 40cm apart to the wall (or overhang) with the supplied screws. ![]() The clips can be fixed vertically or horizontally as shown. This light can be fixed underneath an overhang such as a windowsill, above a garage door or fixed directly to a wall. To reset the sensor simply turn it off at the mains or unplug it then reconnect after 10 seconds, this will recalibrate the sensor. There is a built in 60 second dwell time, the light will stay on for 1 minute after seeing movement – is there something that is constantly moving in front of the sensor?Īre there other heat sources moving within 8m of the light? A hot air vent, road traffic or some other moving object that could be triggering the sensor? Light stays on or is on most of the time at night Is the motion sensor able to see the movement – is there anything blocking the sensor that might prevent it from detecting human movement? Try waving your hand directly in front of the light when it’s dark. Is it dark enough? The light only works when the light level falls below 20 lux – this is night time but perhaps there is another light source that is affecting the sensor? Make sure the power cable has not been damaged during the installation.Ĭheck that the red LED is flashing – so we know the light is powered and ready. *Please check your operator’s manual for compatibility.Ĭheck that the plug in power adapter is plugged in to a working wall socket that is turned on.Ĭheck that the in-line power connector to the light is pushed in securely. Night Sabre can be connected directly to most garage door operators’ AUX port*. Replacing incandescent bulbs with LED units lowers greenhouse gas emissions and saves electricity – the LEDs will last 10-20 years depending on use, so there is a very low total cost of ownership. Installation is quick and simple and there is no need for any adjustments or maintenance – Night Sabres are guaranteed for 2 years. The light is powered by a plug in power supply (included) and the power lead can be easily routed through a window opening or through a small hole in the wall or eaves. An integrated photocell ensures the lights operate only after dusk. As an additional deterrent there is a flashing red LED warning light to indicate the presence of an active security device. At only 32mm high these beautifully crafted aluminium devices can fit under a windowsill, above a door or under the eaves of a roof.Ĭapable of detecting human movement up to 9m away, once triggered 1400 lumens illuminates a wide area with a bright even beam. ![]() ![]() Night Sabre low profile security lights deliver the very latest in high brightness LED technology in a sleek and discreet weatherproof form. Night Sabre LED Security Flood Light with 9m PIR Motion Sensor ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |